THIS PAGE IS UNDER CONSTRUCTION

DTVKit’s Native IP Implementation is an additional module in DVBCore. The architecture of the NIP module is outlined in the diagram below:

<IMAGE GOES HERE>

The NIP module is compatible with both GSE and MPE delivered NIP streams. The module performs MPE or GSE-Lite HEM decapsulation and FLUTE transport file extraction for NIP configuration files: NIF/SIF/DVB-I and Mutlicast Gateway Config. For chosen services the module then manages the retrieval and caching of the associated DASH MPD and AV segment data. All data is cached in a RAM file store, which is managed by the NIP module the size of which is configurable. Note: Playback of a NIP service is not supported by the DVBCore module and this is left to the application to implement. The NIP service lists and associated AV content can be accessed via native APIs which can also be mapped to a simple http server (e.g. mongoose) to provide http endpoints for service list information and AV (DASH) content.

Steps:

For example:

• Example: 10847 (frequency in MHz) - 9750 = 1097MHz
• Then, you need to multiply this number by 1000 to get it in KHz
• Example: 1097MHz * 1000 = 1097000KHz
• This is then the name of the transport stream - 1097000.ts.
• Note this is the MPE based NIP services that use a transport stream service.
• For GSE bas NIP streams the naming convention is the same except that the application with expect to read a PCAP file.
  • For the example above for a GSE/PCAP file the name would be – 1097000.pcap
  • The DTVKit App currently only supports Manual tuning for satellite tuning for DVB-NIP.
  • The parameters for the frequency to enter use this equation:
  • Frequency (e.g. 964) + LNB (9750) = 10714

The DTVKit Application does not support native playback of NIP services as these are typically DASH or HLS based. Instead, the NIP module includes a simple HTTP server that makes DVB NIP services available for playback using a web based or standard desktop player such as VLC. The list of DVBNIP services is presented as the index page of the HTTP server together with all files in the RAM file store including the dash MPDs and associated AV segment data.

The NIP module builds as part of DVBCore but to enable it the following options must be configured in the ‘example_setenv.sh’

<IMAGE GOES HERE>

In additional the following additional libraries are required in your build environment:

• libxml2-dev

Once these prerequisites are met then DVBCore can be built in the normal way, and it will produce a library with the NIP functionality enabled.

The DTVkit Application can then be built in the usual way for the desktop PC. (See instructions here) The application is able to read transport stream (MPE), or PCAP (GSE) files from the “ts” folder in the App’s root directory. For NIP services the application is expecting a satellite stream, so the file needs to be named as the L-band frequency, i.e. the Ku-band frequency specified on the scan dialog minus the LNB frequency, e.g. for a universal LNB, 9,750MHz for low band, and 10,600MHz for high band.